Grabo PRO-LIFTER 20 Manual Del Operador página 16

6) SERVICE
EN
NL
a. Have your power tool serviced by a qualified
DE
repair person using only identical
FR
replacement parts. This will ensure that the
ES
safety of the power tool is maintained.
IT b. Never service a damaged battery. Service of
battery should only be performed by the
SE
manufacturer or authorized service
DK
providers.
AR
RU
VACUUM LIFTING DEVICE SAFETY
TR
WARNINGS / INSTRUCTIONS
a. Do not deliberately try to rip the load off
with extreme force. There is a risk of the
load crushing feet and hands and damaging
the object and tool.
b. Do not lift objects weighing more than 170
kg (375 lbs). There is a risk the weight can fall
off.
c. Risk of load crushing feet and hands and
damaging the object and tool. Do not shake
the tool while lifting, moving and placing
objects. Do not swing or shake the load
while lifting, moving and placing objects. Do
not use the tool when the seal is worn out.
Lift and carry the load with uniform speed
without sudden sharp and strong
movements.
d. Do not use the tool while the battery is low.
There is a risk of injury and damage to the
materials being lifted.
e. If the sealing force begins to noticeably
decrease while the battery is fully charged,
check the rubber foam seal for wear and
tear or damage. Do not attempt to lift
anything with the tool until you have
replaced the seal.
f. Use caution when lifting large thin flexible
sheets, like drywall, cardboard, plastic,
plywood, thin sheet metal etc. Thin sheets
bend and flex and can unexpectedly change
curvature above their limit and detach.
g. Do not attach the tool to surfaces with
visible puddles of water. Internal
components are not waterproof. If water is
sucked into the air ducts it can cause
permanent damage to the tool. The
16
GRABO® Pro-Lifter 20 is not waterproof
and therefore extreme caution should be
taken when using it in the rain or wet
conditions.
h. Do not drop the tool from heights above 1.5
meter above the ground (chest level). If
dropped by accident, inspect the seal side
lips for damage.
i. Do not place heavy objects on top of the
tool.
j. Do not place the digital display in direct
sunlight or near strong heat sources for
prolonged periods. Extreme heat may
damage the display and it may become
unreadable. A damaged display does not
necessarily impact the functionality of the
tool.
k. To avoid overheating, do not cover the tool.
l. Ensure the switch is in the off-position
before transporting the tool and when in
storage. Be mindful that the tool is not
switched on accidently.
m. NOTICE: Due to the high pressure that is
created with the GRABO® Pro-Lifter 20 we
strongly recommend that you do not
attempt to attach the GRABO® Pro-Lifter
20 to glass thinner than 6mm thick.
Damage can occur to glass that is thinner
than 6mm thick.
! WARNING: Weight may drop without
warning if the safety precautions are not
met! The GRABO® Pro-Lifter 20 creates a
strong vacuum. In case the seal is broken or
the allowed weight is exceeded or any other
factor that causes the negative pressure to
release spontaneously, this kind of failure
will happen suddenly and absolutely
without any sensory indication or warning.
You will not notice the weight detaching
and there will be no possibility to stop or
catch it. This is very dangerous, especially
with heavy loads. Therefore all safety
precautions should be kept to the
maximum.