Logging - MELAG Vacuclave 550 Manual De Uso

Water management
In the Settings > Water management menu you can change the water supply and disposal.
Water supply
You can set the feed water supply to Automatic or Manual.
Designation
Automatic
Manual
Water disposal
You can set the wastewater disposal to Automatic or Manual.
Designation
Automatic
Manual

Logging

Further information on the logging settings and the output media can be found in the chapter
Log output
In the Settings > Log output menu, you can set how the log should be output by default for each output medium.
You can activate the log output for several output media at the same time.
For each output medium, one of the following options can be selected for the Log output:
Option
Deactivated
Manual
Automatic (immediately
after program run)
For the option Automatic a dialogue follows for the definition for which programs the automatic log output should take
place.
See also:
▪ Log list [} page 36]
▪ Log output options [} page 37]
▪ Output media [} page 38]
Description
The feed water is automatically supplied via the MELAdem feed water connection.
Before starting the program, the feed water tank must be filled manually.
The required amount is about three litres.
PLEASE NOTE: The feed water tank must be filled up to the MAX mark before
each program start.
Description
The wastewater is automatically disposed of via the wastewater funnel into the
building's wastewater installation.
The wastewater is disposed of via the overflow funnel into an external wastewater
container. The tank is monitored by a level sensor and must be emptied regularly.
Emptying every working day is recommended. The capacity of the wastewater
container is at least 10 cycles.
Description
No log output
Manual log output
Automatic log output after end of the program for the
defined programs
11 Settings
Logging [} page 35].
45