Power Ratings; Parts And Accessories - Briggs & Stratton Victa 46 23HP Manual Del Operador

PROBLEM LOOK FOR
Mower cut is uneven. Mower not leveled
properly.
Rider tires not inflated
equally or properly.
Mower cut is rough Engine speed too slow.
looking.
Ground speed too fast.
Engine stalls easily with Engine speed too slow.
mower engaged.
Ground speed too fast.
Cutting height set too
low.
Discharge chute jamming
with cut grass.
Excessive mower Blade mounting hardware
vibration. is loose.
For all other issues, see authorized dealer.
Specifications
ENGINE
Briggs & Stratton
Intek™ Series
Displacement

Power Ratings

The gross power rating for individual gasoline engine models is labeled in accordance with SAE (Society of Automotive Engineers)
code J1940 Small Engine Power & Torque Rating Procedure, and is rated in accordance with SAE J1995. Torque values are
derived at 2600 RPM for those engines with "rpm" called out on the label and 3060 RPM for all others; horsepower values are
derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.COM. Net power values are
taken with exhaust and air cleaner installed whereas gross power values are collected without these attachments. Actual gross
engine power will be higher than net engine power and is affected by, among other things, ambient operating conditions and
engine-to-engine variability. Given the wide array of products on which engines are placed, the gasoline engine may not develop
the rated gross power when used in a given piece of power equipment. This difference is due to a variety of factors including,
but not limited to, the variety of engine components (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application
limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing
and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this engine.
Note: The engine information contained in this manual applies
to Briggs & Stratton engines only. For information regarding
non-Briggs engines, refer to the engine manual supplied with
your unit.

Parts And Accessories

See an Authorized Service Dealer.
REMEDY
See Mower Deck
Leveling .
See Maintenance
section.
See engine speed control
to FAST.
Decrease ground speed.
Set engine speed control
to FAST.
Decrease ground speed.
Cut tall grass at
maximum cutting height
during first pass.
Cut grass with discharge
pointing toward
previously cut area.
Tighten to 50-60 ft-lbs
(68-81 Nm).
44.18 cu in. (724 cc)
Professional Series™
Displacement
All Engines
Oil Capacity
Spark Plug Gap
Spark Plug Torque
CHASSIS
Fuel Tank Capacity
Inflation Pressure
- Front Wheels
- Rear Wheels
TRANSMISSION
Type
MOWER
Width of Cut
Cutting Height
44.18 cu in. (724 cc)
64 oz (1,9 L)
0.030 in. (0,76 mm)
180 in-lbs (20 Nm)
3 gal (11,4 L)
22 psi (1,52 bar)
12 psi (0,83 bar)
Hydro-Gear® EZT®
Hydro-Gear® ZT-2800®
42" (107 cm)
44" (112 cm)
46" (117 cm)
48" (122 cm)
52" (132 cm)
1.5" - 3.75" (3,8 - 9,5 cm)
1.5" - 4.5" (3,8 - 11,7 cm)
21