Briggs & Stratton Victa 46 23HP Manual Del Operador página 13

C Ignition Switch - starts engine
D Engine Speed Control - controls
engine speed
E PTO Switch - engages and
disengages mower blade clutch
F Hour Meter
G Transmission Release Levers -
release transmissions so unit can roll
freely
H Fuel Tank Cap
I Operator's Seat Adjust
J Left Ground Speed Lever - controls
speed and direction of left drive
wheel
Operation
Oil Recommendations
Oil Capacity: See the Specifications section.
We recommend the use of Briggs & Stratton Warranty Certified
oils for best performance. Other high-quality detergent oils are
acceptable if classified for service SF, SG, SH, SJ or higher.
Do not use special additives.
Outdoor temperatures determine the proper oil viscosity for the
engine. Use the chart to select the best viscosity for the outdoor
temperature range expected.
Engine off
Engine on (run)
Engine start
Choke on (closed) -
Briggs engines only
Engine speed fast
Engine speed slow
PTO engage - pull up
A
on switch
B
Indicates total hours of
engine operation
C
See Pushing the Unit
by Hand D
Turn cap
Check Oil Level
counterclockwise to
remove
See Figure: 3
See Seat Adjustments
Before adding or checking the oil
Forward ground speed • Make sure the engine is level.
increase - push lever
• Clean the oil fill area of any debris.
forward
Neutral - release lever
1. Remove the dipstick (A, Figure 3) and wipe with a clean
cloth.
Engine start - move
lever out
2. Install and tighten the dipstick (A, Figure 3).
Reverse ground speed
3. Remove the dipstick and check the oil level. Correct oil level
increase - pull lever
is at the top of the full indicator (B, Figure 3) on the dipstick.
back
4. If oil level is low, slowly add oil into the engine oil fill (C,
Figure 3). Do not overfill. After adding oil, wait one minute
and then recheck the oil level.
Note: Do not add oil at the quick oil drain , if equipped. For
location, see Features and Controls.
5. Reinstall and tighten the dipstick (A, Figure 3).
Oil Pressure
If the oil pressure is too low, a pressure switch (if equipped) will
either stop the engine or activate a warning device on the
equipment. If this occurs, stop the engine and check the oil level
with the dipstick.
If the oil level is below the ADD mark, add oil until it reaches
the FULL mark. Start the engine and check for proper pressure
before continuing to operate.
If the oil level is between the ADD and FULL marks, do not
start the engine. Contact an authorized dealer to have the oil
pressure problem corrected.
Fuel Recommendations
Fuel must meet these requirements:
SAE 30 - Below 40 °F (4 °C) the use of SAE 30 will result in hard
starting.
10W-30 - Above 80 °F (27 °C) the use of 10W-30 may cause increased
oil consumption. Check oil level more frequently.
Synthetic 5W-30
5W-30
13