Assembling The Ku 1 Curve On The Bs 1 Belt Section - Bosch Rexroth KU 1 Instrucciones De Montaje

3 842 531 106/2013-04 | TS 1
Please note:
• Support the BS 1 belt section
with SZ 1 leg sets, if l > 2000 mm.
Assembly of the KU 1 with variable
infeed/outfeed section L1/L2
1. Insert 4 centering pins (J) each
with the cylindrical end in the
front of the drive heads (D),
so that the chamfer sticks out.
2. Insert 2 hex-socket screws (K)
each from the inside through
the front of the drive heads.
3. Place the BS 1 belt section on
the centering pins.
Please note:
• Do not jam or bend the toothed
belt!
4. Bolt the BS 1 belt section to the
drive heads (the thread is pre-
cut in the BS 1 section profi le).
Assembling the KU 1 curve on the
BS 1 belt section
1. Remove the spacer (L) from the
drive heads (D).
Dispose of the spacer (L).
2. Connect the KU 1 curve to
the BS 1 belt section in the
T-grooves of the drive heads
using 2 KU 1/BS 1 connectors
(M).
6.8 Assembling the KU 1 curve on the BS 1 belt
section
2
1
3
Fig. 4 Assembling the variable infeed/outfeed section L1/L2 on the KU 1 curve
1
L
SW3
M = 5Nm
D
Fig. 5

Assembling the KU 1 curve on the BS 1 belt section

Bosch Rexroth AG
K
4
SW4
M = 8Nm
D
M
2
19/38
531 106-08
531 106-18