Fluke 3563 Guía De Funcionamiento Básico página 36

4. Apply the adhesive using a wooden spatula. Spread the adhesive evenly to the
base of the mounting adapter and the mounting surface (approx. 1 mm / 3/64"
thick ).
5. Affix the mounting adapter by pressing it into the mounting surface, using a
turning motion to evenly distribute the adhesive. (If the centering pin is used,
screw the mounting adapter all the way into the prepared hole.)
Do not remove excess adhesive. If necessary, apply additional adhesive around
the mounting location for greater stability. If necessary, use adhesive tape to hold
the mounting adapter in place during hardening.
33
Adhesive Mounting