Getting started with Analysis Vibration Sensor System
Commissioning sensors
With at least one gateway commissioned, the user may now commission sensors.
1. Make sure sensors are correctly powered. If battery terminals were protected
during transport ensure that the insulation is removed. Refer to page 38 for
details on powering the sensor.
2. From the Home screen, tap Add New in the Sensors frame to open the Add
Sensors screen.
Add sensors using one of these methods.
Automatically — Tap the Auto Detect On/Off button to automatically find
sensors. All detected sensor will appear on the Sensors screen.
NOTE: Sensors are detected automatically only if they are in the vicinity of a
powered gateway, which must be commissioned and connected to Accelix™.
Manually — Tap Manually to proceed to Add Manually screen.
16