Fluke 3563 Guía De Funcionamiento Básico página 33

Getting started with Analysis Vibration Sensor System
4. Bore out hole by drilling with a 6.8 mm (17/64") drill bit.
5. Tap threads into the hole using an M8 (UNC 5/16) tap. Blow any shavings out
of the hole with compressed air.
6. Apply petroleum jelly on the contact surface of the mounting adapter then
screw the adapter into place and tighten the adapter down using the
specially designed wrench together with a torque wrench.
Tighten the sensor with 6 Nm of torque.
30