Battery Charging (Only For Version With Optional Hybrid Kit Installed) - Nilfisk Advance SW5500 Instrucciones De Uso

BATTERY CHARGING (only for version with optional hybrid KIT installed)

09/2016
CAUTION!
Charge the batteries with the installed battery
charger when the last segment of the battery icon
each job. Keeping the batteries charged make
their life last longer.
Recharging is essential when the multifunction
display shows screen (B).
WARNING!
When the batteries are discharged, charge them
as soon as possible, as that condition makes
their life shorter.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (51) to "0".
3. Connect the battery charger plug (D) to a mains electrical
socket.
WARNING!
Check that the voltage and frequency shown on
the battery charger plate (D) match the mains
supply values.
NOTE
When the battery charger is connected to the
electrical mains, all machine functions are
The multifunction display shows the screen (C) as in
4. When the battery charger green battery symbol (E) is
5. When the battery charger green battery symbol (E) is lit
steadily, the batteries are charged.
6. For further information about the battery charger operation,
see the Battery Charger Manual.
7. Disconnect the battery charger cable from the electrical
mains.
(A, Fig. 27) starts flashing
automatically cut off.
the figure.
flashing, the batteries are recharging.
INSTRUCTIONS FOR USE
, or at the end of
CHARGE
1467287000 - SW5500
Figure 27
OK
E
ENGLISH
35
P100924
A
B
C
D