Engine Air Filter Check/Cleaning - Nilfisk Advance SW5500 Instrucciones De Uso

ENGINE AIR FILTER CHECK/CLEANING

09/2016
performance. When working in particularly dusty areas, clean or
program.
CAUTION!
wearing.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (51) to "0".
3. Open the engine compartment hood (19) and fasten it with
the support rod (44).
4. Lift and remove the right side panel (31).
5. Remove the wing nut (A, Fig. 25) and remove the cover
(B).
6.
element.
7.
8.
maintenance table).
9.
compressed air [at no more than 207 kPa (2.1 kgf/cm)]
be damaged.
10. Clean with a wet cloth the base and the cover (B) of the air
11. Fit the foam filter (E) on the paper filter (D), then install
12. Install the cover (B) and screw down the wing nut (A).
A dirty air filter limits the passage of air, thus reducing engine
replace the filters more often than specified in the maintenance
Running the engine without air filters, or with
damaged filters, can cause a faster engine
Remove the wing nut (C) and disassemble the filter
Separate the paper filter (D) from the foam filter (E).
Check both filters and replace them if necessary. Replace
the paper filter (D) when required (see the scheduled
To reuse the filters, clean them both by blowing
inside the filter. Do not use a brush, otherwise the fiber will
filter. Take care to prevent dirt entering the air duct (G).
the assembled filter element. Ensure that the gasket (F) is
properly placed under the filter element. Screw down the
filter element wing nut (C).
INSTRUCTIONS FOR USE
1467287000 - SW5500
Figure 25
ENGLISH
P100928
A
B
C
D
E
G F
33