Main Broom Replacement - Nilfisk Advance SW5500 Instrucciones De Uso

MAIN BROOM REPLACEMENT

ENGLISH
26
WARNING!
It is advisable to wear protective gloves when
replacing the main broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level ground and engage the
parking brake.
2. Ensure that the main broom is in the lifted position.
3. Turn the ignition key (51) to "0" and remove it.
4. Remove the left door (A, Fig. 10) by turning the fasteners
(B).
5. Pull the knob (C, Fig. 11) as indicated by the arrow to
disengage the closing support (D).
6. Turn and open the closing support (D) together with the left
side skirt (E).
7. Remove the main broom (F, Fig. 12).
8. Check that the drive hub (G) is free from dirt or foreign
materials (cords, rags, etc.) accidentally rolled up.
9. The new main broom must be installed with the bristles
10. Install the new main broom and ensure that the hexagonal
11. Turn and close the closing support (D, Fig. 11); when
closing, slightly pull the knob (C) until it clicks.
NOTE
When closing, manually push the main broom to
engage it in the conical hub of the closing support
(D).
12. Refit the left door (A, Fig. 10) and close it with the fasteners
(B).
CAUTION!
Check and adjust the main broom height as
shown in the previous paragraph.
rows bent as shown in the figure (H).
mesh (I) fits into the relevant drive hub (G).
INSTRUCTIONS FOR USE
SW5500 - 1467287000
Figure 10
Figure 11
Figure 12
B
E
G
H
I
09/2016
P100904
P100905
P100906
B
A
C
D
E
F