Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PARKING BRAKE
ENGLISH
Hybrid motor (optional)
Stopping the machine
18
1.
Perform steps 1 to 3 of the machine start-up paragraph.
2.
3.
Check the battery charge while working. While at least one segment of the battery icon
it is advisable to start the engine, or else to recharge the batteries using the on-board battery
charger (see procedure in the Maintenance chapter).
4.
5.
When the multifunction display shows screen (B), a complete battery charging cycle must be
performed using the on-board battery charger. Complete the job in progress before taking the
machine to the area for charging its batteries.
6.
Perform a complete charging cycle before using the machine again (see procedure in the
Maintenance chapter).
1.
To stop the machine, release the accelerator pedal (5).
2.
To stop the machine quickly, also press the service brake pedal (6).
WARNING!
The machine regulates its speed in proportion to the pressure on the accelerator pedal, accelerating and
decelerating as a result. In some particular working and environmental conditions (e.g. steep descents), the
automatic deceleration may deactivate itself to protect the system. For this reason, always use the service brake
3.
In case of emergency, press the emergency push-button (69) to immediately stop the machine.
To deactivate the emergency push-button (69), turn it clockwise.
WARNING!
4.
Turn the ignition key (51) to "0" and remove it.
1.
Engage the parking brake by pressing the pedal (6) and engaging the lever (7).
2.
Disengage the parking brake by pressing and releasing the pedal (6).
WARNING!
Before performing any maintenance, repair, cleaning or replacement procedure engage the parking brake.
Engage the parking brake when parking the machine on a slope.
WARNING!
Before leaving the machine unattained, be sure that the parking brake can stop the machine with a large safety
margin.
WARNING!
When using the machine on slopes, respect the maximum gradient values marked on the machine itself (see
technical characteristics table).
Ignition of the engine is not necessary while the batteries retain a sufficient level of charge.
(A, Fig. 1) is lit and not flashing on the multifunction display (71), the machine can be used
with the engine off. When the battery icon (A) has only one flashing segment remaining
To start using the machine again with the engine off, press the push-button (36) and hold it
down until the engine turns off.
(6) to be sure of the machine's stopping distance.
The emergency push-button (69) also deactivates the machine's automatic deceleration system; if operated
while moving, use the service brake (6) to stop the machine.
INSTRUCTIONS FOR USE
SW5500 - 1467287000
09/2016
,
Figure 1
P100924
A
B
Publicidad
Tabla de contenido
