Scheduled Maintenance Table; Machine Long Inactivity; After Using The Machine - Nilfisk Advance SW5500 Instrucciones De Uso

MAINTENANCE

AFTER USING THE MACHINE

MACHINE LONG INACTIVITY

SCHEDULED MAINTENANCE TABLE

09/2016
After working, before leaving the machine, perform the following procedures.
–
– Empty the hopper (12) (see the procedure in the previous paragraph).
– Raise the brooms with the One-Touch push-button (52).
– Close the safety valve on the LPG tank (32), then let the engine run until all the fuel is expelled from the hoses (then the
engine is stopped).
–
– Engage the parking brake.
NOTE
If the machine is left parked and inoperative, with the ignition key (51) in the "I" position, for more than 5 minutes, the
and restart the machine with the ignition key (51).
If the machine is not going to be used for more than 30 days, proceed as follows:
– Perform the procedures shown in After Machine Use paragraph.
– Check that the machine storage area is dry and clean.
– Close the LPG tank safety valve.
– Disconnect the negative connector (-) of the batteries (47).
– Handle the engine (43) as shown in the relevant Manual.
–
Maintenance chapter).
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
Center.
CAUTION!
Each time the Service icon
scheduled maintenance.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
batteries must be disconnected.
Read carefully the instructions in the Safety chapter before performing any maintenance procedure.
Procedure
Engine oil level check
Side and main broom height check
Activate the filter shaker briefly by pressing the push-button (57).
Turn off the machine by turning the ignition key (51) to "0", then remove it.
electrical system switches to a low power consumption mode (stand-by). To start work again, it is necessary to shut off
(For machines equipped with dust guard system). Empty the tank (23) and clean the water filter (see the procedure in
which are to be defined by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorized Service
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the
Battery fluid level check
Engine air filter check
Hopper dust filter check and cleaning ("A" method)
INSTRUCTIONS FOR USE
is shown on the display (71), contact an authorized Advance Service Center for
Upon
delivery
(1)
1467287000 - SW5500
Every 10 Every 50
hours hours
(2)
(1)
(3)
ENGLISH
Every Every
Every
100 200
year
hours hours
21