Skirt Height And Operation Check - Nilfisk Advance SW5500 Instrucciones De Uso

SKIRT HEIGHT AND OPERATION CHECK

ENGLISH
Preliminary Operations
Side Skirt Check
Front and Rear Skirt Check
Reassembly
30
1. Empty the hopper (as shown in Use chapter), because the
height check.
2. Drive the machine on a level ground that is suitable for
checking the skirt height.
3. Turn the ignition key (51) to "0" and engage the parking
brake.
4. Remove the left and right doors (14 and 13) by turning the
fasteners.
NOTE
The right door fasteners (13) must be turned with a
tool.
5. Check the condition of the side skirts (A, Fig. 18) and (B).
Replace the skirts when they have cuts (C, Fig. 19) larger
than 20 mm or cracks/tears (D) larger than 0.4 in (10 mm)
(for skirt replacement, refer to the Service Manual).
6.
Fig. 18) and (B) is within 0 and 0.12 in (0 and 3 mm) (E,
Fig. 20).
If necessary, loosen the nuts (F, Fig. 18) and adjust the
skirt position. Finally, tighten the nuts (F).
7. Remove the main broom as shown in the relevant
paragraph.
8. Check the condition of the front (G, Fig. 21) and rear skirts
(H) and (I).
Replace the skirts when they have cuts (C, Fig. 19) larger
than 20 mm or cracks/tears (D) larger than 0.4 in (10 mm).
9. Check that the front (G, Fig. 21) and rear skirt (I) slightly
rub ground without being detached from it (J, Fig. 20).
10. For the skirt replacement, see the Service Manual.
11. Assemble the components in the reverse order of
disassembly.
weight of the waste inside the hopper can affect the skirt
Check that the distance from the floor of the side skirts (A,
INSTRUCTIONS FOR USE
SW5500 - 1467287000
Figure 18
Figure 19
Figure 20
Figure 21
F B
> 10 mm
(> 0,4 in)
D
E
0÷3 mm
(0÷0,12 in)
G
09/2016
P100912
P100913
P100914
P100915
A F
F
C
> 20 mm
(> 0,8 in)
J
FRONT
H I