Multifunction Display Service Screens - Nilfisk Advance SW5500 Instrucciones De Uso

MULTIFUNCTION DISPLAY SERVICE SCREENS

Main screen (E, Fig. 3)
Machine Settings Screen (F, Fig. 4)
09/2016
1. Turn the ignition key (51) to the starting position "I" while
holding down push-buttons (52) and (53) to access the
main screen (E, Fig. 3).
2. Press push-button (A) to change the machine settings (see
the Machine Settings Screen paragraph).
3. Press push-button (B) to check any alarms stored by the
machine (see the Alarms Memory Screen paragraph).
4. Press push-button (C) to check the machine working hours
(see the Hour Counter Screen paragraph).
5. Press push-button (D) to exit super user mode and return
to operator mode.
This function allows you to customize the value of the
parameters.
1. To increase the value of the current parameter, press
push-button (C).
To decrease the value of the current parameter, press
push-button (D).
2. To move to the next parameter, press push-button (A).
3. To return to the main screen, hold down push-button (B).
(*)
TABLE OF MODIFIABLE PARAMETERS
Code Description
VSL Side broom speed
SCF Filter shaker activation time
FVMIN Minimum forward speed
FVMAX Maximum forward speed
RVMAX Maximum reverse speed
BAT (*) Installed battery type (see table)
TOFF
BRGH Display contrast
RESET Resets all parameters to the factory default values
Installed Battery type
WET Battery with liquid acid electrolyte
GEL / AGM Generic GEL or AGM batteries
parameters described in the following table of modifiable
Automatic shut-off time
Significant only when the Hybrid Kit is installed
INSTRUCTIONS FOR USE
1467287000 - SW5500
Figure 3
Figure 4
Minimum
50%
5 sec
0%
10%
10%
0
0 sec
5
0
Value
0
1
E
F
ENGLISH
Values
Factory Setting Maximum
100% 100%
20 sec 60 sec.
25% 100%
85% 100%
30% 50%
0 1
300 sec 600 sec
25 50
0 1
P100897
P100898
23
A
B
C
D
A
B
C
D