Engine Oil Level Check And Replacement - Nilfisk Advance SW5500 Instrucciones De Uso

ENGINE OIL LEVEL CHECK AND REPLACEMENT

ENGLISH
Engine oil level check
Engine oil change
32
CAUTION!
Running the engine with a low oil level can
damage the engine itself.
NOTE
The oil alert system will automatically stop the engine
before the oil level goes down under the safety limit.
To avoid a sudden engine stop, always check the oil
level before each start-up.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (51) to "0".
3. Open the engine compartment hood (19) and fasten it with
the support rod (44).
4. Lift and remove the right side panel (31).
5. Remove the cap (A, Fig. 24).
6. Check the oil level. If it is below the upper limit (E), top up
with the recommended oil until you reach the upper limit.
7.
CAUTION!
The discharged engine oil must be disposed of
properly according to the Law in force.
NOTE
It is advisable to change the oil when the engine is
8. Perform steps 1 to 4 of the previous procedure.
9. Remove the cap (A, Fig. 24).
10. Unhook the drain hose (B) and bring it towards the outside
of the machine.
11. Remove the drain plug (C) from the hose and drain the oil
return the hose to its initial location.
12. Remove the filler cap (D) and pour in the new oil through
NOTE
As for engine oil type and quantity, see the Technical
Data chapter and the Engine Manual.
13. Reinstall the filler cap (D) and the cap (A) safely.
Reinstall the filler cap (A) safely.
still hot, to make the oil downflow easier.
into a suitable container, then refit the oil drain plug and
the filler until it reaches the upper limit (E) of the cavity.
INSTRUCTIONS FOR USE
SW5500 - 1467287000
Figure 24
E
09/2016
P100926
E
C
A
B
D