Panel Dust Filter Cleaning And Integrity Check - Nilfisk Advance SW5500 Instrucciones De Uso

PANEL DUST FILTER CLEANING AND INTEGRITY CHECK

Method "A"
Method "B"
09/2016
WARNING!
–
–
–
– Wear appropriate dust mask to avoid
breathing in dust.
1. Drive the machine on a level ground, engage the parking
brake and turn the ignition key (51) to "0".
2. Open the engine compartment hood (19) and fasten it with
the support rod (44).
3. Release the fasteners (A, Fig. 16) and open the vacuum
system cover (B).
4.
machine.
5.
surface (with the dirty side down) to remove dust and dirt.
NOTE
past the gasket.
CAUTION!
be damaged.
for 15 minutes, then rinse it under a gentle stream of water
installing it back into the machine.
and non-lathering detergents.
This provides better quality cleaning but reduces the life of the
6.
following:
•
•
17).
•
replaced.
7. Press the lever (E) to disengage and close the cover (B,
Fig. 16).
8. Engage the fasteners (A).
The dust filter must be regularly cleaned to maintain the
efficiency of the vacuum system. Follow the recommended filter
service intervals for the longest filter life.
Wear safety glasses when cleaning the filter.
Do not puncture the filter.
Clean the filter in a well-ventilated area.
Lift the dust filter (C, Fig. 17) and remove it from the
Clean the filter using one of the methods below:
Collect dust from the filter. Gently tap the filter against a flat
Take care not to damage the metal lip which extends
Collect dust from the filter. Blow compressed air (maximum
pressure 6 Bar) into the clean side of the filter (in the opposite
direction of the airflow).
Method "C" (only for optional polyester filter)
For the paper filter: do not use water or
detergents to clean it, otherwise the filter could
Collect dust from the filter. Then soak the filter in warm water
(maximum pressure 2.5 Bar). Let the filter dry completely before
For a better cleaning, it is allowed to wash the filter with water
filter, which will have to be replaced more frequently. The use of
inadequate detergents can damage the filter.
Install the filter in the reverse order of removal and note the
Clean the filter housing.
Install the filter with the wire gauze upwards (D, Fig.
If the filter gasket is damaged or missing, it must be
INSTRUCTIONS FOR USE
1467287000 - SW5500
Figure 16
Figure 17
A
ENGLISH
P100910
P100911
B
A
E
D
C
29