TensCare Sure PRO Instrucciones De Uso página 27

it will start with the last programme
used.
Each time you press and release the
PROG button, the programme will
change, and the screen will display the
programme selected.
Each time you change the programme,
the intensity will reset to zero. This
safety feature prevents
unpleasant changes in stimulation,
since each programme produces a
different sensation.
The backlight turns off 5 seconds after
the last button press.
TREATMENT TIMER
The default setting for
+
preset programmes is
MENU
shown on the screen.
To alter the Treatment Timer setting,
press +Menu or -Menu. The display will
flash. Use + and - buttons to adjust the
treatment time. Then press  to accept
the change.
You can set session times of C
(continuous) or 5 to 60 minutes in 5
minutes steps. Programmes 4, 6, 7 & 8
are preset programmes with fixed
treatment times.
MANUAL SETTINGS
When a programme has manual
settings available, MANUAL will be
displayed on the screen.
Press +Menu or -Menu buttons to cycle
through parameters. The
parameter will flash. Press + or - to
adjust the setting. Press 
the change, and the flashing will stop.
Parameters cycle through Hz, µs,
WORK, REST, RAMP, TIMER, DATE,
TIME.
MANUAL PROGRAMME LOCK
When MANUAL is showing, you can
protect the manual settings (or default
settings) by pressing and holding 
button for 3 to 5 seconds.
unlock simply press and hold button 
sudden
for 3 to 5 seconds again.
USAGE MEMORY
Date and time Setting:
The date (Day of month) and time (Hour
of day) can be set. This enables the
memory to give an exact history of daily
-
usage.
MENU
To set date and time, press +Menu and
cycle through parameters to DATE.
Centre left shows Day of month and
centre right shows Hour. Day is
flashing. Adjust with + and - buttons
and set with  button.
To set Hour, press +Menu and cycle
through parameters to TIME. Adjust
with + and - buttons and set with 
button.
Memory Mode:
A: Day of month
B:
number for day
C: Programme
used
recording
selected
D: Duration of recording
to accept
E: Average intensity for recording
If no programme has been used for
more than 9 minutes, a NULL message
26
This symbol will appear on the
screen and will flash if you try
to adjust manual settings. To
Recording
for this