Preparing For Session - TensCare Sure PRO Instrucciones De Uso

protocols use both vaginal and anal
electrodes).
2) Insert the lead wire plug into the base
of the unit.
3) Connect the lead from the base of
the unit to the lead in the probe.
Push the pin ends firmly into the pigtail
ends of the probe lead.
For PAIN and TIBN, use the self-
adhesive electrode pads.
The lead wires may be damaged by
rough handling, and should be treated
with care.
Lead wire colour coding.
The ends of the lead wire are coloured
black or red. This coding is provided for
some professional uses. For most
purposes, the orientation makes no
difference, and you can ignore this
colour coding.
13.3. PREPARING FOR
SESSION
1) Before using Sure PRO you will
need to visit the toilet.
2) Lubricate the
surfaces and probe tip with a water-
based lubricant, such as TensCare
Go Gel or water.
Caution: Do not use a silicone
based lubricant
stimulation contacts as it may
decrease the effectiveness of the Sure
PRO's muscle stimulation.
metal electrode
on the
29
3) Choose a comfortable position,
such as lying down on your bed on
your side with your knees raised.
Warning: Ensure the Sure
PRO is switched OFF before
inserting the probe.
4) After the wire is securely connected,
insert the probe into your vagina, in
the same way as you would a
tampon, until only the plastic rim at
the base of the probe is visible.
5) The probe will naturally position
itself with the widest part of the
flange vertically. The metal parts
conduct the electrical pulse and
should be in contact with the main
part of the muscle at all times. The
tissues close to the entrance are
more sensitive, so you should avoid
stimulating them.
Metal plates
Note: The flange should not be
inserted into the vagina and
Flange