Orbitalum RPG 3.0 Traducción Del Manual De Instrucciones Original página 44

eNGLISH
Information and safety instructions for the responsible body
DANGeR!
DANGeR!
DANGeR!
DANGeR!
DANGeR!
DANGeR!
DANGeR!
DANGeR!
DANGeR!
44
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
If the mains cable is damaged, live parts may cause death if touched directly!
Fatal electric shock.
X Do not allow the power cable of the motor to be near the machine, especially the
cutting tool (MFW).
X Do not run the machine unattended.
X During processing, always keep an eye on the position of the mains cable.
X Keep the machine clean. Always remove lubricant residues from the machine.
Damaged insulation!
Fatal electric shock.
X Do not screw any indicators or signs to the drive motor.
X Use stickers.
Metal dust can collect in the motor housing and cause loss of insulation!
Fatal electric shock.
X Depending on the level of contamination, clean the machine at least once a day using the
brush supplied.
Damaged mains plug!
Fatal electric shock.
X Do not use adapter plugs with ground protected electrical tools.
X The machine connector plug must fit the socket.
Risk of danger through the use of the machine outdoors!
Fatal electric shock.
X Do not use the machine in wet surroundings.
Danger! The electrical motor can overheat with operation in a 110 V network!
Serious injury or death.
X Only use the machine in the specified temperature range.
Grounded body!
Fatal electric shock.
X Avoid contact with grounded surfaces such as tubes, heating, cookers or refrigerators.
Loose/baggy clothing, long hair or jewelry can get caught in rotating
machine parts!
Serious injury or death.
X Wear tight-fitting clothing during work.
X Tie up long hair to prevent it from being caught.
Safety components that are contaminated or worn are defective!
The failure of safety components can cause physical injury.
X Do not misuse the cable, e.g. such as using it to suspend or carry the machine.
X Replace defective safety components immediately and check them daily to ensure
proper operation.
X Clean and perform maintenance on the machine after each use.
X Keep cables away from heat, oil, sharp edges and moving equipment parts.
X Inspect the machine daily for visible signs of damage or defects, and have them repaired
by a specialist if necessary.
RPG 3.0, RPG 4.5 (S), RPG 8.6
[REV. 20210302] OC_RPG_L_BA_790038761_01__INH-02_EN