Orbitalum RPG 3.0 Traducción Del Manual De Instrucciones Original página 45

RPG 3.0, RPG 4.5 (S), RPG 8.6
WARNING!
WARNING!
WARNING!
WARNING!
[REV. 20210302] OC_RPG_L_BA_790038761_01__INH-02_EN
Information and safety instructions for the responsible body
Parts thrown off/tool breakage and rotating pipe!
Diverse physical injuries and material damage.
X Es dürfen keine beschädigten oder deformierten Schneidwerkzeuge (MFW) verwendet
werden.
X Firmly clamp the tube to be machined into the clamping unit.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X Spannfläche der Spannbacken frei von Schmutz und Spänen halten.
X The inner diameter of the clamping shells must be identical to the outer diameter of the
tube to be machined. The specific inner diameter is specified on the clamping shells. The
outer diameter of the tube must be determined.
X Avoid tool breakage by ensuring low (measured) infeed (max. clamping thickness: 0.2
mm) and correct setting of speed (see chap. 9.2, p. 65).
X Check that the tool holder (WH) and multifunctional tool (MFW) are seated firmly, and
tighten if required.
X After adjusting the tool, remove the hexagon key from the working area.
Falling objects or tilting and bending tubes!
Irreversible crushing.
X Wear safety shoes (in accordance with EN ISO 20345, at least S1).
X Place sufficient supports under the tube.
X Transport the machine as shown in chap. 7.1, p. 55.
Danger caused by vibration and unergonomic, monotonous work!
Discomfort, tiredness and disruptions to the locomotor system.
Limited ability to react, and cramps.
X Do relaxation exercises.
X Ensure activity is varied.
X Assume an upright, fatigue-free and comfortable body position during operation.
Pressing the ON­OFF switch unintentionally!
Diverse physical injuries and material damage.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug or remove the battery.
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
45