Fitting The Multifunctional Tool (Mfw) And The Tool Holder (Wh) - Orbitalum RPG 3.0 Traducción Del Manual De Instrucciones Original

RPG 3.0, RPG 4.5 (S), RPG 8.6
WARNING!
WARNING!
8.1

Fitting the multifunctional tool (MFW) and the tool holder (WH)

1. Screw the multifunctional tool (MFW) onto the tool holder using a Torx screwdriver.
2. Insert the tool holder with fitted MFW laterally into the guiding groove and position it.
3. Press the tool holder against the bearing surface of the tool support and, at the same time, tighten the screw using the Allan
key (1).
4. Remove the hexagon key (1) from working area.
NOTe!
[REV. 20210302] OC_RPG_L_BA_790038761_01__INH-02_EN
Flying, hot and sharp­edged chips, tube surfaces, cutting edges and tools!
Danger of injury to eyes and hands.
X Do not reach into the rotating tool during working.
X Never work without an installed cover hood or protection
X Wear recommended protective clothing, as described in chap. 2.4, p. 43.
X Before transportation or changing the workplace, switch off the machine, wait until the
machine/tool stops running and pull the mains plug. Remove chips with tightfitting
safety gloves (in accordance with DIN EN 388 and EN 407) using suitable tools (e.g.
tongs or screwdriver).
X Ensure that the cover hood or protection is functional
The MFW multifunctional tool may be damaged by wrong inserting of a tube!
Damage to tool.
X Before clamping the tube, ensure sufficient distance between the MFW and the tube.
To make the setting procedure easier for the RPG 3.0 machine, there are 3 visual markings
for 1", 2", and 3" pipes. For the RPG 4.5 (S) machine, 4 visual markings (for 1", 2", 3", and 4"
pipes) are applied at the tool holder (see figure below). For the RPG 8.6, 5 visual markings
are available for 4", 5", 6", 7", and 8" pipes.
Setup and assembly
1
1"
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
4"
3"
2"
57