Shark AI ULTRA ROBOT RV2600WSEU Manual De Instrucciones página 30

1 m
1 m
1.5 m
• Select a permanent location for the Base because every time you relocate the base, your robot will have
to completely re-map your house. Remove protective film from robot and base.
• Place the base with its back against a wall. Select a level surface on a bare floor in a central area with a
strong Wi-Fi signal. Do not place base against baseboard heaters or other heating elements.
• Remove any objects that are closer than 1 metre from either side of the base or closer than 1.5 metre from
the front of the base.
• Plug in the base. Make sure the power switch on the back of the base is in the (I) ON position. The Base
Power Indicator Symbol ( ) on the top right side of the base will illuminate when the base has power.
INSTALLING THE SIDE BRUSH
s h a r kc l e a n . e u
BASE SETUP
The Base Power
Indicator Icon
INDICATOR
Snap the included side brush onto the square peg
on the bottom of the robot. The brush will spin
clockwise when correctly assembled.
NOTE: Side brush design may vary.
ROBOT BATTERY INDICATOR LIGHTS
NOTE: If the low charge light is blinking red, there is not enough battery power for the robot to return to the base.
Manually place the robot on the base.
TIP: To preserve battery life, if the robot will not be used for a long time, turn off the power on the robot by pressing the
DOCK button and holding it for 5-7 seconds. The robot should be recharged at least once every three months.
To turn the robot power off, take it off the Self-Empty Base and press the DOCK button on the robot for
5-7 seconds.
BASE INDICATOR LIGHTS
s h a r kc l e a n . e u
In Use
Full Partial Low
Charge Charge Charge
(White) (White) (Red)
While
Charging
(White)
No Charge
or Off
The white charge indicator lights show how much
battery power is remaining.
While the robot is charging, both white LED lights
will flash. When charging is complete, both will
illuminate steadily. It may take up to 6 hours to fully
charge your robot.
If the robot is idle and away from the charging
base for 10 minutes, it will enter Sleep Mode. The
indicator lights will turn off, but the battery and
Wi-Fi lights will remain on in sleep mode. Wake up
the robot by pressing any button.
Base Power
Indicator Icon
Base is plugged in
and has power.
Charging
Icon
Robot is properly aligned
on base and charging.
No Evacuation
Icon
Robot will not self-empty debris into base.