Shark AI ULTRA ROBOT RV2600WSEU Manual De Instrucciones página 35

MAINTENANCE
CLEANING AND REPLACING THE BASE FILTERS
Regularly clean the filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To open the filter housing lid, hold the top left edge
of the base and pull up on the lid. With the lid open,
remove the foam filter by the top handle, then lift out
the felt filter underneath. Tap the filters clean over
the trash, Tap the filters clean over the rubbish bin,
then rinse them with cold water ONLY, as soap may
damage them. Allow filters to air-dry completely before
reinstalling them. The filters must be installed correctly
for the base to work properly. Reinsert the felt filter
first, then the foam filter.
s h a r kc l e a n . e u
Filter
Door
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door, then
tilt the door and lift it off. Remove the Post-Motor
Filter from the base by pulling the tab down. Tap
the filters clean over the rubbish bin, then rinse them
with cold water ONLY, as soap may damage them.
To reinstall the post-motor filter, insert it into the
base and replace the filter door.
MAINTENANCE
CAUTION: Turn off power before performing any maintenance.
EMPTYING THE ROBOT DUST BINS
To remove the Self-Empty Dust Bin, pinch the release
latches on the front of the dust bin and slide it out.
For the Vac & Mop 2-in-1 Dust Bin, press the release
button at the top of the dust bin and slide it out
Empty debris and dust into rubbish bin. Remove
filter and wash dust bin if necessary.
NOTE: Make sure to insert the dust bin completely, until
it clicks into place.
To open the dust bin lid, press and hold the button
while lifting the lid, using the finger slots.
Look between the filter and the plastic shield and
make sure there is no debris buildup.
s h a r kc l e a n . e u