Shark AI ULTRA ROBOT RV2600WSEU Manual De Instrucciones página 34

MAINTENANCE
EMPTYING THE BASE DUST BIN
The Base Dust Bin holds up to 30 days' worth of
dust and debris. Empty the base dust bin when the
debris level approaches the max fill line.
To detach the bin, press the Dust Bin Release
button on top right side of the base, then slide out
the bin.
s h a r kc l e a n . e u
To empty the bin, hold it over the rubbish bin, then
press the release button with the rubbish bin icon
on the bottom of the bin. The bin lid will open,
releasing dust and debris. Lightly tap the dust bin
against the inside of the rubbish bin receptacle to
knock off any remaining debris. Reinstall the bin by
sliding it into the slot in the base until it clicks into
place.
MAINTENANCE
CAUTION: Turn off power before performing any maintenance.
EMPTYING THE ROBOT 2-IN-1 DUST BINS
To remove the Self-Empty Dust Bin, pinch the release
latches on the front of the dust bin and slide it out.
For the Vac & Mop 2-in-1 Dust Bin, press the release
button at the top of the dust bin and slide it out
Empty debris and dust into trash. Remove filter and
wash dust bin if necessary.
NOTE: Make sure to insert the dust bin completely, until
it clicks into place.
To open the dust bin lid, press and hold the button
while lifting the lid, using the finger slots.
Look between the filter and the plastic shield and
make sure there is no debris buildup.
s h a r kc l e a n . e u