Descargar Imprimir esta página

Shark AI ULTRA ROBOT RV2600WSEU Manual De Instrucciones página 33

Ocultar thumbs Ver también para AI ULTRA ROBOT RV2600WSEU:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 41
USING THE SHARK® AI ULTRA 2-IN-1 ROBOT
VAC & MOP 2-IN-1 SETUP
NOTE: Before it can mop, the robot MUST complete an Explore Run with the Self-Empty Dust Bin attached. After
the Explore Run, you will have an option to set up Carpet Zones and verify those carpets in the app with a Carpet
Verification Run. This ensures your robot will avoid carpets in mopping mode.
Attach the mop pad by inserting the flat edge of the
pad through the slot in the Vac & Mop 2-in-1 Dust Bin.
Pull the mop pad all the way through the slot until it is
securely inserted.
Lift open the fill cap on the top of the reservoir.
Fill with water to the water line.
s h a r kc l e a n . e u
Secure the pad to the Vac & Mop 2-in 1 Dust Bin.
Firmly push the Vac & Mop 2-in-1 Dust Bin into the
back of the robot, and ensure both latches click
into place. The water droplet icon on the robot will
illuminate white when the Vac & Mop 2-in-1 Dust Bin is
inserted properly.
USING THE SHARK® AI ULTRA 2-IN-1 ROBOT
VAC & MOP 2-IN-1 SETUP
NOTE: When mopping, your robot may travel over floor mats or rugs. Before the next mopping run, move
rugs or mats out of the robot's path, or use the app to set up Carpet Zones or no-go zones.
When the reservoir in the Vac & Mop 2-in-1 Dust Bin
has fluid and is properly installed, with the mop pad
attached, the robot is ready to vacuum and mop
simultaneously. Press the CLEAN button on the robot
or in the app to start a vacuuming and mopping run.
The robot will prime the mop pad for 30 seconds
before starting its run.
To remove the mop pad from the Vac & Mop 2-in-1
Dust Bin, detach the pad from the reservoir and slide
the pad out of the slot.
When mopping is complete, remove the Vac & Mop
2-in-1 Dust Bin by pressing the fill port button and
sliding it out. Empty the reservoir after each use and
manually clean out the dust bin.
CAUTION: Floors may be slippery after mopping.
To prevent your robot from traveling over rugs and
carpets in mopping mode, set up Carpet Zones in
the app.
s h a r kc l e a n . e u

Publicidad

loading