Festool CSC SYS 50 EBI Manual De Instrucciones página 41

The hex key cannot be
inserted into the open­
ing on the type plate.
The cutting angle does
not match the indica­
tion on the display.
The cutting height does
not match the indica­
tion on the display.
Reference movement
failed
The sliding table and
plate are not at the
same height.
The extension table
and plate are not at the
same height.
The sliding table can
no longer be moved
fully into both posi­
tions.
The sliding table is dif­
ficult to move.
Splintering during saw­
ing
Motor runs with re­
duced power
The saw blade is not in the
parked position.
Cutting angle shifted.
Cutting height shifted.
An area cannot be reached.
End stops dirty.
Sliding table height shifted.
Extension table height shif­
ted.
Maximum lift shifted.
Dirty tracks.
Ball bearings dirty.
The parallel side fence for
free cuts has shifted.
Motor temperature too high.
Speed has been reduced to
allow the ventilator to cool
the motor quickly.
Move the saw blade to the parked position with
the control module (see section 9.8).
Calibrate the cutting angle (see section 9.7).
Calibrate the cutting height (see section 9.5).
Clean the end stops (see section 12.6).
Adjust the height of the sliding table (see sec­
tion 12.2).
Adjust the extension table height (see sec­
tion 12.1).
Adjust the maximum sliding table lift (see sec­
tion 12.3).
Clean the tracks with a cloth (see section 12.4).
Contact an authorised service workshop or the
manufacturer.
Alignin the parallel side fence to the saw blade
(see section 12.7).
The power tool starts up again automatically
once the motor has cooled sufficiently.
Only continue working once cooling down has
concluded.
English
41