8.
To tighten the brace, slip your thumbs through the holes in the pull tabs.
Pull away from your body. When tightened, secure the pull tabs to the loop
exterior. (Figure E)
NOTE: When sitting, loosen the compression by detaching the pull tabs. This will
help to address the brace from moving up on the patient's torso.
BRACE REMOVAL
9.
Detach the pull tabs from the loop exterior to loosen the brace. Unhook
donning mitt from the loop exterior and remove brace.
HOT/COLD PACK (SOLD SEPARATELY)
10. Follow instructions on hot/cold pack. Insert hot/cold pack into pocket and
adhere to back panel.
ADJUSTING PULL TAB LENGTH (OPTIONAL)
11.
Remove lace spool from the pull tab pocket and wind lace around the spool to
shorten the length of the pull tab. Unwind lace from the spool to lengthen the
pull tab. (Figure F)
12. Insert lace spool back into pull tab pocket.
INSERT/REMOVE FRONT PANEL
13. Open inside panel pocket. Remove semi-rigid panel. (Figure G)
14. Open inside panel pocket and insert semi-rigid panel.
ATTACH/REMOVE SOFTGOODS (FOR CLEANING)
15. Removal of soft goods: Open rear panel pouch and detach waist belt. Remove
rigid rear panel from pouch. Waist belt: Detach rear panel section by unlooping
waist belt from lacing guide panel. Remove semi-rigid front panel from inside
panel pocket of waist belt. Wash soft goods per instructions below. (Figure H)
16. Attaching soft goods: Waist belt: Reattach tall, rear panel section by looping
waist belt through lacing guide panel. Open inside panel pocket of waist belt
and replace semi-rigid front panel. Insert rigid rear panel into pouch. With tall,
rear panel pouch open, lay waist belt on top with lacing guide facing up. Close
pouch.
CLEANING INSTRUCTIONS: Separate the brace's removable REAR PANEL
before cleaning.
Hand wash in water (86°F/30°C), using mild soap. Air dry.
NOTE: If not rinsed thoroughly, residual soap may cause irritation and
deteriorate material.
Do NOT iron.
Do NOT tumble dry.
Do NOT bleach.
MATERIAL CONTENTS: Nylon, Polyester, Polyethylene, Polyurethane, Cotton,
Acrylic, Polypropylene, Calcium Carbonate, PVC, Synthetic Rubber, Silicone, EVA.
WARRANTY: DJO, LLC will repair or replace all or part of the unit and its
accessories for material or workmanship defects for a period of six months from
the date of sale. To the extent the terms of this warranty are inconsistent with
local regulations, the provisions of such local regulations will apply.
RX ONLY
INTENDED FOR SINGLE PATIENT USE.
LATEX
NOT MADE WITH NATURAL RUBBER LATEX.
NOTICE: WHILE EVERY EFFORT HAS BEEN MADE IN STATE-OF-THE-ART TECHNIQUES TO
OBTAIN THE MAXIMUM COMPATIBILITY OF FUNCTION, STRENGTH, DURABILITY AND
COMFORT, THERE IS NO GUARANTEE THAT INJURY WILL BE PREVENTED THROUGH THE USE OF
THIS PRODUCT .
3