Publicidad
Idiomas disponibles
Idiomas disponibles
Riduttori e Variatori
Istruzioni per installazione ed uso
11. LUBRICATION
Proper lubrication makes for:
Lower friction;
Less heating;
Increased efficiency;
Lower oil temperature;
Less wear.
Check the oil level before starting up the unit; this operation must be carried out when the unit is arranged
in the predetermined mounting position, if necessary restore the level with oil of the same type shown on
the nameplate (see the table ALTERNATIVES TO FIRST SUPPLY LUBRICANTS). In case of unavailability,
please contact MOTOVARIO TECHNICAL SERVICE. For possible use of different oil (after checking with
MOTOVARIO TECHNICAL SERVICE), change completely and in case of synthetic oil, only after washing the
inside of the reducer. Fill the oil through the special holes or the inspection cap using a filling filter, then
restore the gasket (to be replaced) or the sealant.
PLEASE NOTE: For units supplied without oil, check, in the specific additional nameplate, the oil that
may be used and the required quantity according to the mounting position and specify the indications
required on the same nameplate. Fill the unit with oil following the plug diagram.
If there is an oil leak, find the cause before restoring the lubricant level.
Do not dump the lubricant in the environment, adopt all the necessary environmental safety measures,
dispose of the lubricant in compliance with the current regulations.
In case of ambient temperature not listed in the table, contact MOTOVARIO TECHNICAL SERVICE. If the temperature is
lower than -30 °C or higher than 60 °C use special mixture sealing rings.
For oil changes follow what indicated in the "ORDINARY MAINTENANCE Table".
Periodically check that oil level is never below the minimum level; this operation has to be carried out with
stopped gear reducer and after cooling.
120
QL0214 ∕ REV.6
Publicidad
