Publicidad
Idiomas disponibles
Idiomas disponibles
6. Care, Cleaning & Maintenance
WARNING! Risk of serious or fatal injuries due to electric shock!
Before any cleaning work, disconnect the device completely from the electrical supply outlet!
•
Never allow moisture to get on or into the power supply unit or the cable!
•
Never open or repair the power supply unit or cable! In case of problems, contact the
•
customer service!
WARNING! Danger of injury and damage to property!
Never use the device if any components are loose or damaged.
•
If possible, tighten connections. If necessary, arrange for repair.
•
•
In all cases of doubt, contact customer service.
CLEANING
•
After training, remove sweat from the device with a dry or slightly damp cloth. Do not use aggressive
detergents. Never allow moisture to penetrate a housing.
•
Make sure that the nameplate and other stickers are intact and legible.
MAINTENANCE
•
Before and after each training session, check that the device is in perfect condition. Also check that
all fastening parts and protective covers are in place and intact. Tighten bolts and nuts if necessary.
•
The unit is equipped with sealed bearings. Lubrication is not required.
STORAGE
•
To move the device on the rollers, lift it only by the handle of the rear stand. When moving, make sure
that the monitor does not hit, swivel and/or collide.
•
The storage location of the device must meet these requirements:
-Dry and clean interior, free of explosive or flammable substances and dust
- Temperature within the permissible range for operation (see technical data)
- No direct sunlight
•
For longer storage, protect against dust.
7. Error handling
Error
Device cannot be
switched on
Pulse display 'Err' or no
pulse display
Error message 'E...'
Device wobbles or
squeaks
In all cases of doubt, contact our customer service. You find the contact details on the last page.
44
Possible reason
Power cable not plugged in
Cable on computer loose
Sensor handles gripped too
loosely or too tightly
Cable on computer loose
Pulse chest strap not put on
correctly
Communication error
Device is not level
Connections are loose
Possible solution
Plug in power cable (chap. 2.11)
Check cable (chap. 2.8/ 2.9)
Grip sensor handles moderately
Check cable (chap. 2.8/ 2.9)
Check/correct pulse strap
Contact customer service (see back of this
manual)
Align device with foot stamps (chap. 2.1)
Check/tighten screw connections
Publicidad
