HPA-Faip M 824 LL Uso Y Mantenimiento página 51

- Once you have mounted the bottom
bead, repeat the same steps for the
upper bead (fig.23).
NOTE: Ensure that the bead passes over
the tail of the head (Fig. 24).
- Tilt the column backwards, release
the wheel and remove it from the tyre
changer.
Operator's manual M 824 LL
APPROVED UHP
AND RUN FLAT
TYRE DEMOUNTING
AND MOUNTING
PROCEDURE
For a detailed description of the
UHP and RUN FLAT tyre mounting/
demounting procedure, please refer
to the instructions in the manual pre-
pared by WDK (German Tyre Industry
Association).
LOW PROFILE
23
- Position the mounting/demounting tool
correctly against the edge of the rim (Fig.
25), as described for soft-walled tyres.
24
- Push the hydraulic control lever down
(Fig. 26) to place the hook under the bead
(Fig. 26).
NB: Ensure that the bead of the lower
side of the tyre has not been re-mounted
back onto the rim.
TYRES
Demounting
EN
25
51