Dacor Pro DOP30 840 Serie Manual De Instrucciones página 77

Burner grates and components
Turn off all surface burners and make sure they have all cooled down.
1
2
3
CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by force.
• Make sure all burner components (heads and caps) are reinstalled properly. When
installed properly, they are stable and rest flat.
• To avoid chipping, do not bang grates and caps against each other or hard surfaces
such as cast iron cookware.
The burner ring can be blocked by food or dust. Clean the ring if it appears blocked.
•
If you clean the spreader with water, assemble it only after it is completely dry. If
the ring is wet, it might prevent the burners from igniting.
DOP30T840GS_DG68-01458A-00_EN+MES+CFR.indb 77 DOP30T840GS_DG68-01458A-00_EN+MES+CFR.indb 77
1. Remove the burner grates.
2. Remove the burner caps from the
burner heads.
1
3. Remove the burner heads from the
valve manifolds to reveal the starter
2
electrodes.
4. Clean the grates and burner
components in warm, soapy water. (Do
3
not use steel-wool pads or abrasive
cleaners.)
5. Rinse and dry grates and burner
components thoroughly. Ensure the
burner ports are free of water.
6. Reassemble the burner heads, making
sure to insert a starter electrode through
the hole in each head.
NOTE
See page 80 for details on how to
reassemble the burner components.
7. Reassemble the remaining burner
components, making sure the caps lie
flat on top of the heads.
8. Re-install the burner grates in their
respective positions.
9. Turn on each burner to verify that it
works properly, then turn off the burner.
English 77
2023-01-12 오후 2:41:20 2023-01-12 오후 2:41:20