Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
8.
Place the lip of the
solution tank on the
handle bracket and
rotate it up so that
the solution tank pin
engages the solution
tank pin retainer.
(Fig. 8)
9.
Pressing the white
tab on the connector
will release the elbow
connector from the tank.
(Fig. 9)
10. Attach the hose barb end of the
black elbow connector to the hose
coming from the pump housing.
Attach the other end of the elbow
to the tank by pushing the elbow
into the connection until it "clicks"
and locks in. (Fig. 10)
11. Attach one end of the power cable
to the unit and the other to a wall
outlet. (Fig. 11 & 12)
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
How it works:
Cleaning liquid in the solution tank is sprayed onto the floor.
The counter rotating brushes scrub the floor and throw the dirty water on the
conveyor drum. The front brush does most of the scrubbing and drying. The rear
brush completes the scrubbing and collects the remaining water from the floor.
The blade fitted to the recovery tank wipes the drum and collects the dirty water.
To put machine in TRANSPORT MODE,
move red lever to the DOWN position. In
this mode, the transport wheels contact
the floor when the handle is moved to
the working position.
Note: The machine will NOT turn on
when in this mode.
14
CONTROLS
BRUSH CONTROLS
The handle must be in the upright and locked
position to change the transport / work lever.
15
Publicidad
