Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
Prior to cleaning, ensure unit is OFF and
disconnected from power supply.
1.
When floor cleaning operation is
complete, return handle to upright
and locked position and unplug the
power cord. Wrap the power cord
around the hooks on the handle.
2.
Move the transport lever to the
DOWN position to remove brushes
from floor.
3.
Lift the recovery tank lid and
remove recovery tank. Empty tank
and rinse completely with clean
water. Clean steel wiper blade prior
to re-inserting recovery tank.
4.
To prevent possible clogging of the
solution lines, empty any unused
solution from the tank, lines and
filter and flush completely with
clean water. Store dry.
5.
Release brushes by removing brush
shafts held in by quick release
retaining balls.
6.
Remove brushes and wash them
either by dipping in a bucket/sink or
in running water.
20
Avoid touching the sharp edges of the dirty water
tank as injury to hands can occur.
Dispose of dirty water in accordance with all local, state,
and federal hazardous material disposal regulations.
CLEANING
21
Publicidad
