Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
1.
Insert the handle
assembly into the
handle bracket.
(Fig.1)
2.
Using the knob,
star washer and flat
washer, fasten the
handle to the handle
bracket. (Fig. 2)
3.
Ensure the handle
solution tank pin is toward the
front of the unit and the cord
wrap hooks are towards the rear.
(Fig. 3)
4.
Feed the pump control cable
through the (5) locations shown
in the handle bracket and handle.
(Fig. 4)
Fig. 1
Fig. 2
Fig. 3
1
2
3
4
5
Fig. 4
5.
Plug the end of the pump control
cable into the socket in the handle
assembly. This plug is not polarity
sensitive and will fit into the handle
either way. Ensure there is enough
slack at the bottom of the cable
so that the pump housing lid is not
raised when the handle is moved to
the working position. (Fig. 5)
6.
Feed the loop of the power cord
through the slot in the power cord
retainer. (Fig. 6)
7.
Hook the loop over the lip of the
retainer and pull any slack back
through the slot. Wrap cord around
4 cord hooks on the back of the
machine. (Fig. 7)
12
ASSEMBLY
Fig. 5
Fig. 6
Fig. 7
13
Publicidad
