Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting Speakers
Note
• Connect speakers with a nominal impedance of 6 ohms to 16 ohms.
• Before connecting cables, be sure to disconnect the AC power cord (mains lead).
• Before connecting the AC power cord (mains lead), make sure that metallic wires of the speaker cables are
not touching each other between the SPEAKERS terminals.
• When you connect a subwoofer with an auto standby function, turn off the function when watching movies.
If the auto standby function is set to on, it turns to standby mode automatically based on the level of the
input signal to the subwoofer, and the sound may not be output.
• If you have two subwoofers, you can connect them to both SUBWOOFER OUT jacks.
How to connect speaker cables
Be sure to connect the speaker cables correctly to the terminals of the speaker and this receiver.
Also, be sure to tightly twist the speaker wire strands and insert them securely into the speaker
terminals.
10mm
(13/32 in)
Note
• Be sure not remove too much of the speaker cable sleeves, so as to prevent the wires of the speaker cables
from touching each other.
• Connect speaker cables properly with the polarities (+/–) matched between the receiver and the speakers.
• Improper connection may result in fatal damage to the receiver.
17
EN
Publicidad
