Publicidad
Idiomas disponibles
Idiomas disponibles
Setting up the Receiver
using the Easy Setup
When you turn on the receiver for the first
time or after the receiver is initialized, the
Easy Setup screen appears on the TV screen.
Note
It is not possible to perform the Easy Setup
procedure using the indications on the front display
panel.
1
Turn on the TV, and then switch
the input of the TV to the
receiver.
2
Press (power) to turn on the
receiver.
You can also turn on the receiver using
(power) on the remote control.
3
Follow the on-screen
instructions to select items
using / / / , and confirm
with
.
Language
Set the language to be displayed on screen.
Close
BACK
42
EN
English
Français (France)
Français (Canada)
Español
Deutsch
If the Easy Setup screen does not appear
or you want to display the Easy Setup
screen manually, you can display it by
pressing HOME, then select [Setup] –
[Easy Setup].
Setup
0.
Easy Setup
1.
Input Settings
2.
Speaker Settings
3.
Network Settings
4.
HDMI Settings
5.
Audio Settings
6.
Zone Settings
BACK
Back
What you can do with Easy Setup
By performing Easy Setup, you can complete:
1: Language selection
2: Auto Calibration
Check your speaker system and perform
Auto Calibration according to the
configuration and arrangement of your
speaker system.
3: Internet Settings
Select the network connection method and
configure settings to connect the receiver
to the network.
Performing Auto Calibration
(D.C.A.C. IX)
Before you perform Auto
Calibration
• Disconnect the headphones.
• Remove any obstacles between the
calibration microphone and the speakers.
• When [Bluetooth Mode] is set to
[Transmitter], cancel the setting before
performing Auto Calibration.
• For accurate measurement, make sure the
environment is quiet and free from noise.
• Set the speaker output to a setting other
than "SPK OFF." See "Selecting the front
speakers" (page 43).
Publicidad
