Publicidad
Idiomas disponibles
Idiomas disponibles
• Confirm the subwoofer setup
– Before using a subwoofer, turn on the
subwoofer and turn up the volume. Turn
the LEVEL to just before the mid-point.
– When a subwoofer with a crossover
frequency function is connected, set the
value to maximum.
– When a subwoofer with an auto standby
function is connected, set it to off
(deactivated).
Note
Depending on the characteristics of the
subwoofer you are using, the setup distance
value may be different from the actual position.
Auto Calibration operation
Auto Calibration is performed twice.
– 1st calibration: Place the microphone on the
mic stand top ().
– 2nd calibration: Rotate the microphone
90 degrees and place it on the mic stand
bottom ().
Note
• The speakers emit very loud sound during the
calibration and the volume cannot be adjusted.
Be considerate of your neighbors and any
children who are present.
• If the muting function has been activated before
you perform Auto Calibration, the muting
function will shut off automatically.
• It may not be possible to take the correct
measurements or to perform Auto Calibration
at all if special speakers such as dipole speakers
are used.
• If the measurement fails, follow the message,
then select [Retry]. For details on the error code
and warning message, see "List of messages
after Auto Calibration measurements"
(page 59).
To cancel Auto Calibration
The Auto Calibration function will be canceled
when you perform the following operations,
etc. during the measurement process:
– Press (power).
– Press the input buttons on the remote
control or turn the INPUT SELECTOR on the
receiver.
– Press (muting), HOME, AMP MENU or
HDMI OUT.
– Press SPEAKERS on the receiver.
– Change the volume level.
– Connect the headphones.
For details on Auto Calibration, visit the Help
Guide.
Selecting the front speakers
SPEAKERS
Press SPEAKERS repeatedly.
The indicators on the display panel shows
which set of terminals are selected.
• SPA: Speakers connected to the
SPEAKERS FRONT A terminals.
• SPB*: Speakers connected to the
SPEAKERS SURROUND BACK/HEIGHT
(FRONT B/BI-AMP/ZONE 3) terminals.
• SPA+B*: Speakers connected to
both the SPEAKERS FRONT A and
SPEAKERS SURROUND BACK/HEIGHT
(FRONT B/BI-AMP/ZONE 3) terminals
(parallel connection).
• (None): "SPK OFF" appears on the display
panel. No audio signals are output from any
speaker terminals.
* To select "SPB" or "SPA+B", set
[Surround Back Speaker Assign] in
[Speaker Settings] to [Front B].
Note
This setting is not available when headphones are
connected.
43
EN
Publicidad
