Publicidad
Idiomas disponibles
Idiomas disponibles
Supplied Accessories
• Remote control (1)
• R03 (size AAA) batteries (2)
• FM wire antenna (aerial) (1)
• Calibration microphone (1)
• Calibration mic stand
– Mic stand top (1)
– Mic stand pillar (1)
– Mic stand bottom (1)
Inserting batteries into the
remote control
Insert two R03 (size AAA) batteries (supplied)
in the remote control. Make sure that the +
and – ends are in the correct position when
installing batteries.
6
EN
Note
• Do not leave the remote control in an extremely
hot or humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds
of batteries.
• Do not expose the remote control sensor to
direct sunlight or lights. Doing so may cause a
malfunction.
• If you do not intend to use the remote control for
an extended period of time, remove the batteries
to avoid possible damage from battery leakage
and corrosion.
• When the receiver no longer responds to the
remote control, replace both of the batteries with
new ones.
Assembling the calibration mic
stand
1
Insert the mic stand pillar all
the way into the mic stand
bottom.
2
Insert the mic stand top all the
way into the mic stand pillar.
Mic stand pillar
Mic stand
bottom
Mic stand top
Mic stand pillar
Publicidad
