Descargar Imprimir esta página

Sony STR-AN1000 Manual De Instrucciones página 58

Ocultar thumbs Ver también para STR-AN1000:

Publicidad

Idiomas disponibles

Idiomas disponibles

There is a time gap between the visual
display on the TV and the audio output from
the speaker connected to the receiver.
• Change the [A/V Sync] settings in the
[Audio Settings] menu.
• Adjust the A/V Sync settings on the TV. For
details, refer to the operating instructions
of the TV.
• When the sound field is set to
[Audio Enhancer], change the sound field
to other than [Audio Enhancer]. For details
on the sound fields, see "Selectable sound
fields and their effects" (page 50).
The surround effect cannot be obtained.
• Be sure to select the optimal sound field for
the content. For details on the sound fields,
see "Selectable sound fields and their
effects" (page 50).
• To activate the virtualizer and obtain the
surround effect when the speaker pattern
is set to [2.0] or [2.1], set [Sound Field] to
[A.F.D.], [A.F.D. Movie], [Dolby Mode] or
[DTS:X Mode], set [Upmixer] to [Auto], and
set [Virtualizer] to other than [Off].
Volume level of Zone 2 speakers cannot be
adjusted.
• You can only select an input from the
HDMI IN jacks in Zone 2. Since the
audio signals are output from the
HDMI OUT B/ZONE 2 jack as they are, you
cannot adjust the volume level on the
receiver. Adjust the volume on the device
connected to the HDMI OUT B/ZONE 2 jack.
The center component of the audio is
not output from the TV when using the
TV as a center speaker by connecting
the S-CENTER OUT jack of the receiver to
the S-CENTER SPEAKER IN jack of the TV.
(The Acoustic Center Sync function is not
working)
• Check that [Control for HDMI] is [On] in the
[HDMI Settings] menu.
• Press HOME, select [Setup]
– [Speaker Settings] –
[TV/Screen Center Settings] –
[TV Center Speaker Mode] and then set to
[On].
• Select a sound field other than [2ch Stereo].
• The sound may not be output through
the TV speaker depending on the sound
source.
58
EN
• When a BLUETOOTH device is connected
and [Bluetooth Mode] is set to
[Transmitter], or a headphone is connected,
the sound will not be output through the TV
speaker.
Network connection
Cannot connect to the network.
• Check that the LAN cable is connected to
the receiver when you want to connect the
receiver to the network via a wired LAN
connection.
• Check the network information. If the
connection failed, set up the network
connection again.
• If the receiver is connected through a
wireless network, move the receiver and
the wireless LAN router/access point closer
to each other and perform the setup again.
– Make sure that you use a wireless LAN
router/access point.
– Make sure that the wireless LAN router/
access point is turned on.
– Check the settings of the wireless LAN
router/access point and perform the
setup again. For details on the settings
of devices, refer to the operating
instructions of the devices.
– Wireless networks are influenced by
electromagnetic radiation emitted by
microwave ovens and other devices.
Move the receiver away from these
devices.

Publicidad

loading