Angelo Po FX 82 G3T Manual De Uso E Instalación página 128

REPLACEMENT OF THE BURNER NOZZLE
To carry out this operation, proceed as follows.
1 – Undo the screws to remove the side panel (A).
2 – Disconnect the gas supply line (B).
3 – Remove the injector (C) and replace it with the one suitable for the type of gas in
use (see table at back of manual).
Important
Take care to ensure that the nozzle (C) is correctly positioned (see diagram).
4 – Reconnect the pipe (B), replace the panel (A) and retighten the screws when the
operation is complete.
REPLACING THE FUSE
To carry out this operation, proceed as follows.
1 – Undo the screws to remove the side panel (A).
IT
2 – Open the fuse-holder (B) and replace the damaged fuse (C).
3 – Replace the fuse-holder and the side panel when the operation is complete.
GB
DE
FR
ES
English
A
B
C
B
- 62 -
C
C
A
Use and installation manual
IDM-39619301100.tif
IDM-39617702200.tif