Angelo Po FX 82 G3T Manual De Uso E Instalación página 129

CHANGING THE LAMP
To carry out this operation, proceed as follows.
1 – Undo the screws and remove the lamp cover (A).
2 – Extract and replace the lamp (B).
Caution - warning
During the procedure, take care not to touch the lamp directly; wear protective
gloves if necessary.
3 – Replace the lamp cover (A) and retighten the screws when the operation is complete.
CHANGING THE IGNITION PLUG
To carry out this operation, proceed as follows.
1 – Undo the screws to remove the side panel (A).
2 – Open the tangs (B) and remove the guard (C).
3 – Undo the nuts (D) to remove the ignition plug unit (E).
4 – Replace the guard and close the tangs when done.
English
A
A
E
C
- 63 -
B
B
D
D
Use and installation manual
IDM-39617702300.tif
IT
GB
DE
FR
ES
IDM-39617702300.tif