Publicidad
Idiomas disponibles
Idiomas disponibles
4
Procedure to install the automation and sliding doors
Installation of an automatic sliding door, carried out by professionally competent staff, can only take place after inspections on site (as indicated in
chapter 1) and having measured and created the fixture and the automation.
Fastening to the wall of the box profile must be safe and adequate for the weight of the doors. Distribute the fastening points every 500÷800 mm,
using adequate plugs and screws, not supplied by us, depending on the wall on which fixing is carried out. Drill in correspondence with the groove
provided inside the box.
N.B. The wall must be straight and smooth, otherwise you have to prepare adequate iron shims or plates to fasten the box to, for correct levelling.
4.1 BOX ASSEMBLY
MAX 68 mm
cod. ACG9413
4.2 DOORS ADJUSTMENT AND ASSEMBLY
Fasten the sliding doors to the carriages using the 8MA screws.
Close the doors and adjust the height and depth, as indicated in the figure.
Adjust the position of the upper stop castors to prevent the carriage from exiting the sliding profile.
*
cod. ACG9414
4
OPEN
cod. ACG9449
cod. ACG9450
A
cod. ACG9451
cod. ACG9414
C
A
C
OPEN
cod. ACG9470
cod. ACG9471
cod. ACG9472
B
B
Publicidad
