Publicidad
Idiomas disponibles
Idiomas disponibles
8
Installation of battery-powered device
Fasten the battery-powered device on the box profile
Connect the battery-powered device to the BAT connector of the electronic control, using the cable provided (see paragraph 11).
Check that the battery is connected to the electronic board.
Connect the automation to the power supply and wait at least 30 minutes to allow the battery to recharge.
N.B. to recharge, the battery-powered device must always be connected to the electronic control. In case of long periods of inactivity of the
automatic door, disconnect the battery from the electronic board.
For the operating mode of the automation with the battery-powered device, see the -ON- menu - BTMD parameter.
9
Cover opening and locking
The cover can be locked in the opening position to facilitate installation operations:
1 - Open the casing
2 - Push the casing towards the wall to lock it
When the casing is closed, fasten it to the heads with the screws provided.
To lock the casing, you need a space of at least 20mm over the profile of the door.
Note: A cable gland (P) is pre-installed on the right side of the motor which allows passage of the connection cables. Keep the mains supply separate
from the low voltage device cables.
9
Publicidad
