Publicidad
Idiomas disponibles
Idiomas disponibles
SIO1
Input/Output IO1 setting of the terminal J4.
If used as input, connect the device contact to
the terminals IO1/+24V.
If used as output, connect the load to the
terminals IO1/-24V (ATTENTION!: 30 mA max).
For devices with higher absorption, use a
support relay
SIO2
Input/Output IO2 setting of the terminal J4.
If used as input, connect the device contact to
the terminals IO2/+24V.
If used as output, connect the load to the
terminals IO2/-24V (ATTENTION!: 30 mA max).
For devices with higher absorption, use a
support relay
SIGN
Warnings
SYNC
Doors synchronised.
Synchronisation of up to 2 automation units
via the bus connection
INK
Interlocked doors.
Interlocking of two automation units via the
bus connection
NO
Disabled
INKE
Interlock exclusion contact
KC
Key Close. Priority close command
KOPT
Partial Open Key. Priority partial open command
WARN
Signals, by activating the output, an alarm status that lasts for
more than 5 min (see Alarms paragraph)
To reset, disconnect power supply.
SERV
Signals, by activating the output, the number of manoeuvres has
been reached for maintenance set by the INFO-SERV parameter
SIGN
Output is enabled based on the settings of the ADV-SIGN parameter
BELL
The output allows you to connect an acoustic warning device, in
case of people's passage the output activates for 3 sec.
PART
Input for partial opening contact (see BASE-PART MENU)
EMER
Input for emergency opening contact (NC)
Opening of the contact causes the door to open
SAM
Input configurable with the SAM1/SAM2 menus.
STEP
Input for step by step opening contact (open impulse/lose
impulse). During the opening through the step by step command,
the automatic closure is disabled.
STOP
Input for immediate stop command contact
NO
Disabled
INKE
Interlock exclusion contact
KC
Key Close. Priority close command
KOPT
Partial Open Key. Priority partial open command
WARN
Signals, by activating the output, an alarm status that lasts for
more than 5 min (see Alarms paragraph)
To reset, disconnect power supply.
SERV
Signals, by activating the output, the number of manoeuvres has
been reached for maintenance set by the INFO-SERV parameter
SIGN
Output is enabled based on the settings of the ADV-SIGN parameter
BELL
The output allows you to connect an acoustic warning device, in
case of people's passage the output activates for 3 sec.
PART
Input for partial opening contact (see BASE-PART MENU)
EMER
Input for emergency opening contact (NC)
Opening of the contact causes the door to open
SAM
Input configurable with the SAM1/SAM2 menus.
STEP
Input for step by step opening contact (open impulse/lose
impulse). During the opening through the step by step command,
the automatic closure is disabled.
STOP
Input for immediate stop command contact
KC
Key Close. Priority close command
CLOS
Closed door warning
LAMP
Flashing/light (door in motion)
AIR
Air knife
OPEN
Open door warning
NO
Door closed
SLV2
Unidirectional
MST2
Partial
SLV1
Partial unidirectional
MST1
Door open
NO
No active interlock
EXT
External side automation
INT
Internal side automation
17
Publicidad
