Publicidad
Idiomas disponibles
Idiomas disponibles
6
Return electric lock installation (ACG9454B)
A
The "return" locking device locks the doors in the closed position by
mechanically working on the belt return. The command electronics can
manage the electric lock in locking mode on each door closure, locking in
A
night stop or locking in partial opening (pharmacy function) in the position
defined by the user.
Remove the pre-installed return unit.
Fasten the electric lock/belt return kit using screws A.
A
S
B
A
Tighten the belt using screw B.
ATTENTION!: Wrong adjustment of the belt compromises the good operation of the
automation.
6.1 - Fasten the manual unlocking lever in the desired position using the hole
F.
F
R
L
L
L
Adjust the tightening of the steel cable C with the lever L in the "unlocked"
position and bracket S turned completely left.
For further adjustments, use the adjustment screws R.
L
S
R
S
B
N.B. lasciare un paio di mm. di gioco tra anta e anta.
myone S.r.l - Via T. Abbate, 52 - 30020 Quarto d'Altino (VE) - ITALY Tel. +39 0422 824384 - Fax +39 0422 8
B
B
L
B
R
R
S
R
R
A
6.2 - Use lever L to position the doors completely closed, loosen the 2 screws
V fastening the electric lock to the return bracket, position the lever as
in the figure, turn the electric lock up to couple the counterpart, fasten
the 2 screws again and manually check that the doors are locked.
A
www.myoneautomation.com
Repeat the operation if the doors open more than planned (+/- 2mm ~)
N.B. Leave a couple of mm in range between the two doors.
R
OPEN
6.3
1 - Belt return bracket
2 - Coupling disc
3 - Coupling bracket
4 - Reel casing
5 - Power supply cable
6 - Range adjustment eyelets
7 - Electronic board connector
IMPORTANT: Set the TYLK parameter of the ADV menu on LK1
Apply a table that indicates the near to the release lever manual door
release mode.
6.4 - Connect the electric lock output to the LK terminals of the
command control unit.
3
6
1
7
~2 mm.
~2 mm.
OPEN
4
5
2
6
LK
V
V
Publicidad
