Mounting On Surface; Electrical Installation - WEG SSW-08 Manual Del Usuario

Arrancador suave
Ocultar thumbs Ver también para SSW-08:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.1.3.2 Mounting on Surface

Figure 3.3 shows the installation of the Soft-Starter SSW-08 on the surface of a mounting plate.
Figure 3.3: Installation procedures of the Soft-Starter SSW-08 on a surface

3.2 ELECTRICAL INSTALLATION

DANGER!
The Soft-Starter SSW-08 cannot be used as an emergency stop device.
Always use an isolation contactor or a circuit breaker to disconnect the power supply
of the SSW-08.
DANGER!
Be sure that the AC input power is disconnected before making any terminal
connection.
ATTENTION!
The information below may be used as a guide to achieve a proper installation. Follow
also the applicable local standards for electrical installations.
ATTENTION!
If a power isolating contactor or circuit breaker with minimum voltage coil is not used
at the first power on, then power up the electronics first, adjust the trimpots that are
necessary to put the SSW-08 into operation and only after this energize the power
section.
Installation and Connection
3
SSW-08 | 11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ssw-08 serie

Tabla de contenido