Setting The Ssw; Control Type Setting - WEG SSW-08 Manual Del Usuario

4. SETTING THE SSW-08

This chapter describes how to make the necessary settings for the correct functioning of the
SSW-08.

4.1 CONTROL TYPE SETTING

Select the type of starting control that best adapts to the application.
Voltage Ramp Starting:
This is the most commonly used method. Very easy to program and set.
The Soft-Starter SSW-08 imposes the voltage applied to the motor.
Generally applied to loads with a lower initial torque or a square torque.
This kind of control can be used as an initial working test.
Current Limit Starting:
The maximum current level is maintained during the start, being set according to the application
necessities.
Generally applied to loads with a higher initial torque or a constant torque.
This kind of control is used to adapt the start to the capacity limits of the supply network.
NOTES!
1. The Current Ramp control type, is only programmed using keypad or serial
communication. See the Programming Manual for more details.
2. To program the control type in Pump control, see the Programming Manual or item
5.1.4.
DIP Switch Control
Type Setting
Figure 4.1: Control type setting
Setting the SSW-08
SSW-08 | 25
4