Din-Rail Mounting - WEG CLIC-02 Manual Del Usuario

Installation
4.3 MOUNTING

4.3.1 DIN-Rail Mounting

To install
CLIC-02 must be always installed vertically. Position the clamps on the rear of CLIC-02,
fitting the upper part diagonally and push CLIC-02 toward the rail.
Execute the same procedure to fix the expansion modules. After inserting the expansion
on rail, slide it to the base unit to connect the IOs bus. The top button of the expansion
must be pressed to release this fitting.
Connector
Press the button
DIN rail
CLIC-02 | 31
- English -