Stihl TS 480i Manual De Instrucciones página 10

English
Never operate a cut-off machine that is
damaged, improperly adjusted or not
completely and securely assembled.
Check machine that it is ready for proper
operation.
Keep the handles dry, clean and free of
oil and fuel.
WARNING
Before operation of your cut-off
machine, be sure the controls (e.g.
throttle trigger, throttle trigger lockout,
stop switch) and the safety devices are
working properly, the wheel is properly
mounted, and the wheel guard is in
place and securely fastened to your unit.
All wheels should be carefully inspected
for good condition before mounting.
Adjust the wheel guard
so that sparks, dust and
cut material are deflected
away from the operator,
and cannot reach flam-
mable surroundings. See
section "Operating
Instructions" of your
instruction manual.
WARNING
Check that the spark plug boot is
securely mounted on the spark plug – a
loose boot may cause arcing that could
ignite combustible fumes and cause a
fire.
Proper tensioning of the ribbed V-belt is
important. In order to avoid an incorrect
setting, the tensioning procedure must
be followed as described in your
manual. Always make sure the
hexagonal collar nuts for the cast arm
are tightened securely.
8
Check ribbed belt tension after one hour
of operation and correct if necessary.
Starting
WARNING
Your cut-off machine is a one-person
tool. Do not allow other persons to be
near a running cut-off machine. Start
and operate your cut-off machine
without assistance. For specific starting
instructions, see the appropriate section
of your instruction manual.
Do not drop start. This method is very
dangerous because you may lose
control of the cut-off machine. Place the
cut-off machine on firm ground or other
solid surface in an open area. Maintain
good balance and secure footing. Be
absolutely sure that the cutting wheel is
clear of you and all other obstructions
and objects, including the ground. When
the engine starts at starting position,
engine speed will be fast enough for the
clutch to engage the belt pulley and turn
the wheel. Never attempt to start the cut-
off machine when the abrasive wheel is
in a cut.
Once the engine has started,
immediately blip the throttle trigger,
which should release the starting
position and allow the engine to slow
down to idle.
WARNING
When you pull the starter grip, do not
wrap the starter rope around your hand.
Do not allow the grip to snap back, but
guide the starter rope slowly back to
permit the rope to rewind properly.
Failure to follow this procedure may
result in injuries to hand or fingers and
may damage the starter mechanism.
WARNING
At correct idle speed, the wheel should
not turn. Do not use a cut-off machine
with incorrect idle speed adjustment.
The rotating wheel may cause injury. If
the wheel rotates, have your STIHL
dealer check your cut-off machine and
make proper adjustments or repairs.
Working Conditions
Operate the cut-off machine under good
visibility and daylight conditions only.
Wearing of hearing protection reduces
sound perception. Be alert not to miss
voice signals from co-workers. Keep
within calling distance to other persons
who may assist in case of emergency.
TS 480i, TS 500i